45
Notes
‒
If
“
appears on the display, the sensor for the
element in question must be held down in order to
be able to read off the fault code.
‒
If the fault code is not listed in the table, disconnect
the cooktop from the power supply, wait
30 seconds, and then reconnect it again. If the
display appears again, contact Technical
Assistance Service and tell them the precise fault
code.
The indicator on the tem-
perature sensor flashes
twice.
The battery in the temperature sensor has
almost run out. You may be interrupted
the next time you cook by the battery run-
ning out.
Change the 3V CR2032 battery. See section "Changing the
battery."
The indicator on the tem-
perature sensor flashes
three times.
The temperature sensor is no longer con-
nected.
Press and hold the symbol on the temperature sensor for
8 seconds and then reconnect the temperature sensor to the
cooktop.
“Š‹‹‹
“Š‹‚‹
The supply voltage is faulty, outside of the
normal operating range.
Contact your electricity provider.
—…‹‹
The cooktop is not connected properly
Disconnect the cooktop from the power supply. Ensure that
it has been connected according to the circuit diagram.
š“
The demo mode is activated
Disconnect the cooktop from the power supply. Wait
30 seconds and reconnect it. Touch any control in the next
3 minutes. The demo mode is deactivated.
Display screen
Possible cause
Troubleshooting
Do not place hot pans on the control panel.
Содержание CI 282 610
