Gaggenau CI 282 610, Инструкция по использованию и уходу

Страница: 44 / 96

44
Faults – what to do?
Generally, faults are easy to remedy. Please read the
notes in the table before calling Customer Service.
9
CAUTION
Repairs should only be done by an authorized
servicer.
Improper repair of your appliance may result in
risk of severe physical injury or death.
Display screen Possible cause Troubleshooting
None The power supply has been discon-
nected. Use other electrical devices to check whether a short-circuit
has occurred in the power supply.
The device has not been connected
according to the circuit diagram. Ensure that the device has been connected according to the
circuit diagram.
Electronic fault. If the fault cannot be eliminated, inform the technical after-
sales service.
An audible signal
sounds. The control panel is damp or an object is
covering it. Dry the control panel or remove the object.
”ƒ
/
“‰ƒ‹ˆ
The electronics have overheated and
switched off the corresponding burner. Wait until the electronics have cooled down sufficiently.
Then touch any symbol on the cooktop.
”…
/
“‰ƒ‹‰
The electronics have overheated and have
switched off all burners.
Ӡ
+ heat setting and
audible signal
A hot pot is in the area of the control
panel. There is a risk that the electronics
will overheat. Remove the pot. The fault display goes out shortly after-
wards. You can continue to cook.
Ӡ
and audible signal
A hot pot is in the area of the control
panel. To protect the electronics, the
burner has been switched off. Remove the pot. Wait a few seconds. Touch any control.
When the fault indicator goes out, you can continue to cook.
”‚
/
”‡
The burner has overheated and switched
itself off to protect the work surface. Wait until the electronics have cooled down sufficiently and
switch the burner on again.
”‰
The burner was operating for an extended
period without interruption. The automatic safety switch-off function has been activated.
See section
~
"Automatic shut-off"
”Š
The flex function cannot be activated. Check the fault display, to do this, touch any control. You can
continue cooking as usual with the remaining burners. Con-
tact the technical after-sales service.
“‰ƒ‹ƒ
The temperature sensor is overheated
and the burner was switched off. Wait until the temperature sensor has cooled off sufficiently
before activating the function again.
“‰ƒ‹„
The temperature sensor is overheated
and all burners were switched off. If the temperature sensor is not being used, remove it from
the cookware and keep it far away from other burners and
heat sources. Switch the burners on again.
“‰ƒ‹…
The battery in the temperature sensor is
dead. Change the battery 3V CR2032. See section "Changing the
battery."
“‰ƒ‹†
The temperature sensor is no longer con-
nected. Switch the function off and then on again.
“‰ƒ‹‡
The temperature sensor is broken/defec-
tive. Contact the technical after-sales service.
The temperature sensor
display does not light up. The temperature sensor does not react
and the display does not light up. Change the battery 3V CR2032. See section "Changing the
battery."
If this does not solve the problem, press and hold the symbol
on the temperature sensor for 8 seconds and then recon-
nect the temperature sensor to the cooktop.
If the problem still persists, contact the technical after-sales
service.
Do not place hot pans on the control panel.