Technical Support is available 8am-5pm PST. Monday - Friday
•
702-802-3103
29
Technical Support is available from 8am to 5pm (PST) M - F at [email protected].
33
Stage 3: Align Mirror #1 To Mirror #2
Because the 2nd mirror moves along with the X-gantry alignment must be checked
between mirrors #1 and #2.
1. Open Safety Lid:
You will need to access the interior of the machine.
2. Place Thermal Paper:
Take a small piece of thermal paper (approx. 15 mm should be plenty)
and place it firmly over Mirror #2.
3. Position X-Gantry “Far”:
Jog or manually position the X-Gantry to the lowest position
(as shown in Figure 4.7).
Figure 4.8
4. Close Safety Lid:
Safety measures should make it impossible to fire the laser with the safety
lid open. Regardless, never attempt to fire the laser with safety lid open.
5. Test Fire the Laser:
Press the Fire Laser Icon Button on the touch screen. You will see a burn
mark on the thermal paper.
6. Adjust Red Beam.
Using your 2.5m hex wrench, make micro adjustments to the three
adjustment screws of the red beam diode, and position the red dot exactly over the burn mark. Do not
worry if this places the red dot away from the center of the mirror, we will adjust to center in the next step.
Stage 3:
Align Mirror #1 to Mirror #2
Section IV.
Tests & Adjustments
2. Mirror Alignment Procedure
Because the 2nd mirror moves along with the X-gantry, alignment must be checked between mirrors #1 and #2.
1. Open Safety Lid:
You will need to access the interior of the machine.
2. Place Thermal Paper:
Take a small piece of thermal paper (approx. 15 mm should be plenty) and place
it firmly over Mirror #2.
3. Position X-Gantry “Far”:
Jog or manually position the X-Gantry to the lowest position (as shown in Figure 4.7).
4. Close Safety Lid:
Safety measures should make it impossible to fire the laser with the safety lid open.
Regardless, never attempt to fire the laser with safety lid open.
5. Test Fire the Laser:
Press the Fire Laser Icon Button on the touch screen. You will see a burn mark on the
thermal paper.
6. Adjust Red Beam:
Using your 2.5m hex wrench, make micro adjustments to the three adjustment screws of
the red beam diode, and position the red dot exactly over the burn mark. Do not worry if this places the red dot
away from the center of the mirror, we will adjust to center in the next step.
Содержание MUSE 3D
Страница 1: ......
