Fujitsu PRIMERGY RX600 S3, Руководство пользователя

Страница: 277 / 305

277
PRIMERGY RX600 S3 User’s Guide
9
Op
eration
a
nd
Mainten
ance
9.3 System Event Log
To operate system event log, use Server Management Tools.
` When the area for writing to the system event log is full, the server is set to automatically overwrite
older event logs. For details on this setting, refer to "8.3.13 SEL Logging Submenu" (
J Pg.256) of the
Server menu in BIOS Setup Utility.
9.3.1 How to Use Server Management Tools
This section explains how to use Server Management Tools.
Server Management Tools performs the following to the system event log of the Baseboard Management
Controller (BMC: a micro-controller used for managing the baseboard environment, such as its
temperature and voltage sensors).
• Viewing the system event log
• Saving the system event log
• Deleting the system event log
When a system event log occurs, save the log using Server Management Tools and contact an office
listed in the "Contact Information" of "Start Guide".
` The “Server Management Tools” CD-ROM supplied with this server is exclusively for this server. Do
not use it on other systems. If used it may cause damage to the system.
` Server Management Tools must be used when the server is started using the startup method
discussed below. If started up from other CD-ROMs or hardware disks do not use these tools.
Otherwise, the system may be corrupted.
` Do not eject the CD-ROM when the CD-ROM access LED is on. Doing so may destroy the data on the
CD-ROM.
„
Starting Server Management Tools
` Before rebooting the system from the "Server Management Tools" CD-ROM, first check that the
ServerView "OS Boot Monitoring" function has been disabled (default setting is "Disabled").
If the system is started with this function enabled, the server may automatically turn off or restart
improperly.
If the "OS Boot Monitoring" function is needed, it should be reset to enabled before resuming normal
server operation. For details about ServerView, refer to the "ServerView User’s Guide".
1
Insert the "Server Management Tools" CD-ROM supplied with this server right
after turning the power on.
The system will boot from the CD-ROM and the DOS prompt is displayed.