Fujitsu PRIMERGY RX600 S3, Руководство пользователя

Страница: 254 / 305

254
Chapter 8 Configuring Hardware and Utilities
8.3.9 ASR&R Submenu
Settings for booting control are configured on the [ASR&R] submenu.
table: Items on the ASR&R Submenu
Item Settings Description
O/S Boot Timeout • Enabled
• Disabled (initial value) Set whether or not to enable the "OS Boot
Monitoring" function. The system restarts
automatically in case of stopping booting the OS.
This can be set on the ServerView.
Note:
` Be sure to set “Disabled“ when the
ServerView is not installed to the OS. If you
set “Enabled” in above case, unintended
power-off or restarting may occur.
` Even with the ServerView, when the system is
booted with the ServerStart CD-ROM or DOS
floppy disk, be sure to set “Disabled“. If you
set “Enabled” in above case, unintended
power-off or restarting may occur.
` To set this function, refer to “ServerView
User’s Guide“ to understand the
specifications and operational procedures.
O/S Boot WD Time (min) • 100 (initial value)
• 0
～ 100
Set the time out value by the minute.
O/S Boot WD Behavior • Continue (initial value)
• Reset
• Power Cycle Set the behavior in time out.
ASR&R Boot Delay (min) • 2 (initial value)
• 0
～ 30
Set the standby time between shutdown and
restarting by the minute. When the standby time
passes, the system is restarted.
Power Cycle Delay • 5 (initial value)
• 0
～ 15
Set the time between power off and on.
Boot Retry Counter • 3 (initial value)
• 0
～ 7
Set a maximum number of retrying OS booting.
Diagnostic System
Disabled （ unchangeable ）
This value cannot be changed.
Next Boot Uses Boot Option
(unchangeable) This value cannot be changed.
Diagnostic Lan Device Use Boot Order
(unchangeable) This value cannot be changed.
Temperature Monitoring Disabled (unchangeable) Set whether being possible to turn on the server
outside the range of temperature conditions (10 to 35
degrees C).