FS M6500 Series, Руководство по настройке

Страница: 107 / 185

M6500 Series NE Configuration Manual
106
value expected to be received at the opposite end. That is to say, the two network elements connected by the
overhead should meet the rules as shown in table 6-1
:
Table6-1 Overhead Establishment Rules
NE A Set Relationship NE B
Send TTI SAPI = SAPI Receive TTI
DAPI = DAPI
Receive TTI SAPI = SAPI Send TTI
DAPI = DAPI
6.2. Configuration Steps
6.2.1. SM Configuration Steps
Here we take M6500-MXP10 board as an example to introduce the SM configuration steps:
 Activate the connection and monitoring enablement of SM overhead.
In M Series NMS, the service XGE_GFPF is configured for port 1 of the local end and opposite end of
M6500-MXP10 board (Specific service is configured according to actual demand). OTU4 service is configured for
port 11 of the local-end and opposite-end board (Specific service is configured according to actual demand).
Demultiplex ODU4 to ODU2, configure service cross-connection, connect optical fiber and build the
environment.
Configuration Steps
Click on port 11 at the local end to enter the port management interface of the local end. Click on and
enter“
OTU4 ”option interface, then set“ Path Trace Mismatch (TIM) Mode ” as“ Source & Destination Access
Identifier ”(SAPI&DAPI), and set the status of“ Path Trace Mismatch (TIM) Affects Service ”as“ Yes ”. The opposite-end
SM overhead configuration method is the same as that of the local end, we will not go into much detail here.
Figure6-1 Enter Port Management Interface