FRÄNKISCHE profi-air 250/360 flex, Инструкция по установке и эксплуатации

Страница: 11 / 108

Installation and operating instructions profi-air 250/360 flex
11
3.1 Transport and unpacking
3.3.1 General
3 profi-air 250/360 flex installation
Please handle profi-air flex with utmost care during transport and unpacking.
3.2 Checking the scope of delivery
Please contact the supplier immediately if the delivered profi-air flex unit is damaged or incomplete.
The scope of delivery includes:
n
profi-air flex ventilation unit
n
Control system incorporated into the front of the housing
n
Sheathed 19 mm condensate drain hose incl. 1 clamp connector
n
Fastening rail for wall installation incl. noise separation and spacer
n
Pre-installed 230 V connection cable, 1.7 m length with Schuko plug (type E+F CEE 7/7)
n
Installation and operating instructions
n
Additional label for operating mode B
n
Energy label according to the ErP directive
Check the device type by means of the type plate.
3.3 Requirements for the installation room
n
Frost-free throughout the year
n
Frost-free connection to the wastewater system for units with heat recovery
n
Sufficient space – e.g., silencers, manifolds, pre-heaters or post-heaters may be installed in addition to the ventilation unit
which usually require more space than the unit itself
n
Access to the unit must be ensured for maintenance / cleaning
n
Wall outlets are required for fresh and exhaust air which should neither be below ground level nor directly next to rooms
where a quiet environment is essential (living room, bedroom).
n
Central location of the room reduces routing
n
Statically resilient installation surface
n
If the air induction is effected via an earth-air heat exchanger, the unit should be installed in the basement or on the ground
floor