FRÄNKISCHE profi-air 250/360 flex, Инструкция по установке и эксплуатации

Страница: 51 / 108

P3 P1
P2 P4
A B
P1 P2 [Pa] [m3]
[Pa] [m3]
Einstellwerte / Calibration / Calibrazione
0
100
80
60
40
20
90
70
50
30
10
0
100 50 200 150 300 250 350
[m3/h]
[P a]
Airflow
P3 P4
AUTO
P3 P1
P2 P4
A B
P1 P2
[Pa] [m3]
[Pa] [m3]
Einstellwerte / Calibration / Calibrazione
0
100
80
60
40
20
90
70
50
30
10
0
100 50 200 150 300 250 350 [m3/h]
[P a]
Airflow
P3 P4
AUTO
0
100
80
60
40
20
90
70
50
30
10
0
150 100 250 350 50 200 300
[m 3 /h]
[Pa]
Airflow
Installation and operating instructions profi-air 250/360 flex
51
Step Procedure
4a
Activate the commissioning mode by pushing and holding the “Manual ventila-
tion mode” and the “Automatic mode” buttons at the same time for 5 seconds.
If the commissioning mode has been activated, the two green LEDs will start
flashing and ventilation mode 3 will be indicated.
The commissioning mode remains active for one hour and deactivates functions
(e.g., bypass, frost protection) in order to prevent changes in air ducting and/or
air volume, and to ensure correct setting of ventilation mode 3.
4b
Establish a connection between the ventilation unit and the profi-air cockpit pro
commissioning software. Start the software (profile: Installer / password: 1234).
Select the “Calibration” tab and switch to the commissioning mode by clicking
the “ENTER” button.
The commissioning mode remains active for one hour and deactivates functions
(e.g., bypass, frost protection) in order to prevent changes in air ducting and/or
air volume, and to ensure correct setting of ventilation mode 3.
5
Connect a differential pressure gauge to the extract air channel depending on
the operating mode.
To do so, open the pressure taps at the ventilation unit and connect them to the
measuring device.
Note:
P3
➔
P4 extract air
Operating mode A
Operating mode B
6a
Determine the pressure loss at the heat exchanger on the basis of the air volume
to be set in ventilation mode 3. The required pressure loss can be determined
with the help of the diagram on the ventilation unit.
Note:
P1
➔
P2 supply air
P3
➔
P4 extract air
AUTO
AUTO
Please make sure to switch the unit type before commissioning if an
enthalpy heat exchanger has been installed in the ventilation unit.
Switch to enthalpy in the "Settings / Unit type" menu.
Please make sure to use the respective diagram supplied with the
enthalpy heat exchanger if an enthalpy heat exchanger has been
installed in the unit.