FRÄNKISCHE profi-air 250/360 flex, Инструкция по установке и эксплуатации

Страница: 55 / 108

AUTO
Installation and operating instructions profi-air 250/360 flex
55
Step Procedure
13 Seal the pressure taps.
14a
Deactivate the commissioning mode by pushing and holding the
“Manual ventilation mode” and the “Automatic mode” buttons at the same time
for 5 seconds.
14b Push the “NEXT” button and afterwards “CLOSE” to exit the commissioning
mode.
Following this, you might also have to configure accessory components such as defroster heater, internal
humidity sensor, internal VOC sensor, etc.
Pressure loss diagrams of heat exchangers simplify the setting of the total volume flow rates. Please refer to the description in
the previous Section 4.2.2.
4.2.3 Pressure loss diagram of the heat exchanger
Please pay attention to the type of ventilation unit you are using and what kind of heat exchanger (standard or
enthalpy) has been installed, and select the respective diagram.