Installation Instructions
Specifications are subject to change without notice.
Page 1
[email protected] | www.manrose.co.nz
Distributed by Simx Limited
MultiVent Continuous Extract Ventilation
Thank you for purchasing this quality MultiVent continuous extract ventilation system.
To ensure correct function and safety, please read all instructions before using the product and keep all instructions for future reference.
Description
Product Code
MultiVent Continuous Extract Ventilation System
FAN7200
When using electrical appliances, basic safety precautions should always
be followed to reduce the risk of fire, electrical shock and personal injury.
A
B
C
D
E
F
362
391
111
248
165
97
DIMENSIONS (mm)
SPECIFICATIONS
Duct
(mm)
Max.
Fan Watts
(W)
Max.
Fan Pressure
(Pa)
Free Air Fan Performance
Specific
Fan Power
(W/l/s)
Sound
dB(A)
(l/s)
(m
3
/hr)
125mm & 150mm
85
206
98
505
0.90
52
TECHNICAL
Supply
Max. Operating Temp
IP Rating
Motor Housing
Impeller & Outer Rotor
Weatherproof Cowl
Ducting
220-240V AC, 50Hz
40°C
IPX2
Die Cast Aluminium
PBT Plastic
150mm Stainless Steel
Aluminium Foil
Compliance: AS/NZS60335-2.80:2016
The MultiVent continuous extract ventilation is designed for the simultaneous
ventilation of separate areas in the home and as a multipoint extraction
system for a wide range of commercial applications. The units can be wall,
ceiling or loft mounted. Where the ambient air has a high humidity content
condensate drains are provided.
SEC
Control
Max.
Leakage Rates
Annual Electricity
Consumption
(kWh/a)
Annual Heating Saved
(kWh/a)
Class
Value
Average
Warm
Cold
Factor
Typology
Internal %
External %
Average
Warm
Cold
B
-26.9
-11.4
-54.0
0.65
Local
Demand
Control
<5
<5
0.6
28.3
12.8
55.4
TYPICAL EXTRACTION LOCATIONS - BATHROOMS, TOILETS, LAUNDRIES, KITCHENS
The unit uses a highly efficient backward curved centrifugal motor impeller set and is designed for continuous 24 hour use. Four settable speeds
can be configured to change these speeds based on an integrated sensor or separate switch inputs (not supplied). The unit will run at a normal
flow rate until the humidity sensor or external switch input trigger a speed change. In the case of the switched live and digital inputs, the units
will perform a step change in speed to the appropriate level. In the case of the analog inputs and humidity sensor, the unit can be programmed
to give a proportional response to the change in conditions.
B
B
A
A
C
D
F
E
Ø F
