-72-
Model UR-2 <MENU mode / SYSTEM SETUP menu>
Basic operation of SYSTEM SETUP menu
Though the operation slightly differs depending on the menu item, the basic operation is as follows.
In the following procedure, it is assumed that a new or recorded storage device is set to the unit.
(1)
While the unit is stopped, press the [ENTER]
key to enter the MENU mode.
When you first enter the MENU mode,
"SYSTEM SETUP" is highlighted as shown
below.
(2)
While "SYSTEM SETUP" is highlighted, press
the [ENTER] key.
The SYSTEM SETUP menu screen is shown.
By default, "Default file name" is
highlighted.
(3)
Use the [MENU] dial to select a desired menu
item and press the [ENTER] key.
When you select a menu item with ">" at the
far right, the display shows the next level
screen in the menu. When you select a menu
item without ">", the current setting starts
flashing and you can make setting on this
screen.
Example of selecting a menu item with ">"
The display shows the next level screen.
Example of selecting a menu item without ">"
The current setting starts flashing and you
can make setting on this screen.
For details about each menu item, see the
next pages.
<Memo>:
Pressing the [EXIT] key goes back to
the previous level in the menu. Therefore, press-
ing the [EXIT] key repeatedly exit the MENU
mode. You can exit the MENU mode by a single
press of the [STOP] key.
<Memo>:
When you connect a USB keyboard,
you can operate the SYSTEM SETUP menu from
the keyboard.
Flashing
