-53-
Model UR-2 <Playback>
• Editing the time and days of the week
(2)
Use the [
] and [
] keys to select the item
(hour digit, minute digit, days of the week) to
be edited, use the [MENU] dial to set each item,
and press the [ENTER] key to confirm your
setting.
(3)
Execute the save operation in the same
manner as described on page 51.
• Editing the playback area of a file
<Using the time edit function>
(2)
Use the [
] and [
] keys to select the
flashing point, use the [MENU] dial to enter a
desired value, and press the [ENTER] key to
confirm your setting.
(3)
Execute the save operation in the same
manner as described on page 50.
• Editing the playback area of a file
<Replacing with a CUE time>
(2)
Use the [MENU] dial to select the desired CUE
and press the [ENTER] key to confirm the
selection.
The start (or end) point is replaced with the
selected CUE point.
(3)
Execute the save operation in the same
manner as described on page 51.
(1)
Use the [MENU] dial to highlight "[START]" or
"[END]" and press the [CUE/LOCATE] key.
The CUE list is shown on the display.
<Note>:
To execute the following operation,
more than one CUE point must be set to the
file to be edited. Without any CUE point, you
cannot execute the following operation.
If you replace the start (or end) time with a
CUE time and then edit the CUE time, the
replaced start (or end) time is not affected.
Flashing
(1)
Use the [MENU] dial to highlight "[START]" or
"[END]" and press the [ENTER] key.
The frame digit of the start or end point starts
flashing and you can now edit the value.
(1)
Use the [MENU] dial to highlight
"[TIME&WEEK]" and press the [ENTER] key.
In the initial condition, you can edit the time.
After you finish editing, press the [STOP] key to exit
the MENU mode.
Flashing
