Commissioning
31
3.10
Installing external cleaning agent supply pipework (optional)
The automatic feeder can be equipped with an external cleaning agent supply pipe.
Be sure to comply with the manufacturer's instructions and national regulations for the handling,
use, storage and place of installation of the cleaning agent being used.
WARNING!
Beware of chemical burns from the cleaning agents used.
The cleaning agent can cause chemical burns to your eyes or hands.
►
Always wear goggles and protective gloves when using cleaning agents. Follow all the safe-
ty instructions listed in the safety data sheet for the cleaning agent and wear the specified
safety equipment.
NOTICE!
The cleaning agent container must be positioned so that it cannot be tipped over and so
that calves, unauthorized persons and children have no access to it.
The cleaning agent container can be freely selected. To install it, proceed as follows:
1. In the cover of your cleaning agent container, drill a hole (ø20 mm) for the cleaning agent
lance.
2. Feed the cleaning agent lance from below into the cover of your cleaning agent container.
Slide the upper screw connector from above over the lance and screw it on.
Note:
Slackening the two screw connectors allows the height of the sensor to be adjusted.
3. Unscrew the elbow coupling from the suction lance and remove the upper screw connector.
4. Attach the
transparent hose
which leads from the left hand through coupling to the rear of
the automatic feeder to the sealing cap of the elbow coupling.
Содержание TAP5-VS2-50
Страница 121: ...Appendix 121 10 4 Standard feeding plans ...
Страница 122: ...122 Appendix ...
Страница 129: ...Index 129 Unknown transmitter 101 Water connection 12 Water pressure 24 Weight 12 ...