Ford Taurus, Руководство пользователя

Страница: 893 / 2156

Click to enlarge
To install:
13. Clean and inspect the mating surfaces of the lower and upper intake manifold.
14. Position a new gasket on the lower intake manifold mounting surface. Using
alignment studs will make the job easier.
15. Install the upper intake manifold and throttle body assembly to the lower intake
manifold. If alignment studs are not used, make sure the gasket stays in place.
16. Install the four center retaining bolts and two studs to the upper manifold and
tighten to 8 ft. lbs. (10 Nm). Repeat, in sequence, in two steps:
1. Step 1: 15 ft. lbs. (20 Nm).
2. Step 2: 24 ft. lbs. (32 Nm).
17. Install the two bolts retaining the manifold support brackets to the upper manifold,
then tighten to 19 ft. lbs. (25 Nm).
18. Position the alternator bracket, then install the two retaining bolts to the water
pump and alternator. Install the alternator bracket to the upper intake manifold
retaining nut, then tighten to 19 ft. lbs. (26 Nm).
19. Connect the EGR valve to the EGR tube, making sure that the tube is properly
seated in the EGR valve. Connect the EGR valve to the upper manifold, then
tighten to 19 ft. lbs. (26 Nm).
20. Install the canister purge lines to the fittings on the throttle body.
Upper intake manifold mounting-3.8L engine
Стр . 13 из 31 ELECTRONIC FUEL INJECTION (EFI)
18.11.2005 http://www.chiltondiy.com/content/8687/8687_5_3.html