Ford Taurus, Руководство пользователя

Страница: 336 / 2156

2.5L Engine
1. Properly relieve the fuel system pressure. For fuel system relief procedures,
please refer to Section 1 or Section 5 of this manual.
2. If equipped with an automatic transaxle, remove the transaxle timing window cover
and rotate the engine until the flywheel timing marker is aligned with the timing
pointer.
3. If equipped with an automatic transaxle, place a reference mark on the crankshaft
pulley at the 12 o'clock position (TDC) then rotate the crankshaft pulley mark to the
6 o'clock position (BTDC).
4. Disconnect the negative battery cable.
5. Matchmark the hood hinges for installation reference, then remove the hood.
6. Remove the air cleaner assembly, then position a drain pan under the radiator and
drain the cooling system. Close the drain valve.
7. Disconnect the upper radiator hose at the engine.
8. Identify, tag and disconnect all electrical wiring and vacuum hoses as required.
9. Disconnect the crankcase ventilation hose at the valve cover and the intake
manifold.
10. Disconnect the fuel lines at the fuel rail, then disconnect the heater hoses at the
water outlet connector and the water pump.
11. Disconnect the engine ground wire.
12. Disconnect the accelerator and throttle valve control cables at the throttle body.
13. If equipped, properly discharge the air conditioning system and remove the
suction and discharge lines from the compressor.
14. On manual transaxle equipped vehicles, remove the engine damper brace.
15. Remove the driver belt and water pump pulley.
16. Remove the air cleaner-to-canister hose.
17. Raise and safely support the vehicle.
18. Drain the engine oil, then remove the oil filter.
19. Disconnect the starter cable, then remove the starter motor. For details regarding
starter motor removal, please refer to the procedure earlier in this section.
20. On automatic transaxle equipped vehicles, remove the converter nuts and align
the previously made reference mark as close to the 6 o'clock (BTDC) position as
possible with the converter stud visible.
The flywheel timing marker must be in the 6 o'clock (BTDC) position for
proper engine removal and installation.
21. Disconnect the engine damper at the subframe bracket.
22. Remove the engine insulator nuts.
23. Disconnect the exhaust pipe from the manifold.
the air conditioning system may utilize R-12 or R-134a refrigerant.
These two refrigerants should NOT be mixed, and depending on your
local laws, attempting to service your A/C system could be illegal!
Стр . 6 из 211
18.11.2005 file://C:\DOCUME~1\SILENT~1\LOCALS~1\Temp\trsHIPBC.htm