Ford Taurus, Руководство пользователя

Страница: 96 / 2156

Some vehicles covered by this manual are equipped with and Anti-lock Brake
System (ABS). To check the fluid level in the master cylinder reservoir of a
vehicle equipped with ABS:
1. Turn the ignition OFF.
2. Pump the brake pedal at least 20 times or until the pedal feel becomes hard, then
turn the ignition key to the ON position.
3. Wait at least 60 seconds to be sure that the fluid level is stabilized.
4. The fluid level should be at the MAX line as indicated on the side of the reservoir.
The fluid level will lower somewhat due to normal brake lining wear.
However, if the level is less than half the volume of the reservoir, check
the brake system for leaks. Leaks in the brake hydraulic system most
commonly occur at the rear wheel cylinders or at the front calipers.
Leaks at the brake lines or the master cylinder can also be the cause of
lost brake fluid. If a leak is detected, repair it and bleed the system, as
described in Section 9 .
5. If the level is low, remove the cap and add Heavy Duty Brake Fluid (Dot 3) until the
MAX line is reached. The level of the brake fluid should be at the MAX line
embossed on the translucent plastic reservoir of the master cylinder.
If the master cylinder reservoir has a cap with an expanding rubber
diaphragm, be sure to push the diaphragm up into the cap before
installing the cap.
Power Steering Pump
FLUID RECOMMENDATIONS
Use Ford Motor Company's premium power steering fluid E6AZ-19582-AA (ESW-
M2C33-F) or equivalent.
LEVEL CHECK
You should check the level of the power steering fluid at least twice a year. You
may check the fluid when the engine is either hot or cold.
To check the fluid when the engine is hot:
1. Start the engine and let it run until it reaches normal operating temperature.
2. While the engine is idling, turn the steering wheel all the way to the right and then
to the left several times. Turn the engine OFF.
3. Open the hood and remove the power steering pump dipstick located on the right
side (passenger side) near the front of the engine.
4. Wipe the dipstick clean and reinsert it into the pump reservoir. Withdraw the
dipstick and note the fluid level. The level must show in the FULL HOT range on
the dipstick.
5. If the power steering fluid is low, add the proper fluid in small amounts,
continuously checking the level, until you reach the FULL HOT range, but do not
overfill. Remove any excess fluid with a clean suction bulb or equivalent.
Стр . 18 из 34 FLUIDS AND LUBRICANTS
18.11.2005 http://www.chiltondiy.com/content/8687/8687_1_7.html