Ford Taurus, Руководство пользователя

Страница: 382 / 2156

13. Install the intake manifold supports, then tighten the retaining bolts to 11-17 ft. lbs.
(15-23 Nm).
14. Connect the coolant hoses, throttle position sensor wiring and cables to the
throttle body.
15. Engage all electrical connectors and vacuum lines to the intake manifold.
16. Install the air cleaner outlet tube.
17. Fill the cooling system with the proper type and quantity of coolant.
18. Connect the negative battery, then start the engine and check for coolant leaks.
Check that there is a proper level of coolant, and add coolant if necessary.
3.8L Engine
VEHICLES THROUGH 1993
1. Disconnect the negative battery cable, then properly drain the cooling system.
2. Remove the air cleaner assembly including the air intake duct and heat tube.
3. Disconnect the accelerator cable at the throttle body assembly. If equipped,
disconnect speed control cable
4. Disconnect the transaxle linkage at the upper intake manifold.
5. Remove the attaching bolts from the accelerator cable mounting bracket, then
position the cables aside.
6. Disconnect the Secondary Air Injection (AIR)/thermactor air supply hose at the
check valve.
7. Disconnect the flexible fuel lines from steel lines over the rocker arm cover.
8. Disconnect the fuel lines at the injector fuel rail assembly.
9. Disconnect the radiator hose at the thermostat housing connection.
10. Disconnect the coolant bypass hose at the intake manifold connection.
11. Disconnect the heater tube at the intake manifold. Remove the heater tube support
bracket attaching nut. Remove the heater hose at rear of heater tube. Loosen hose
clamp at heater elbow, then remove the heater tube with the hose attached.
Remove the heater tube with fuel lines attached and set the assembly aside.
12. Tag and disconnect the vacuum lines at the fuel rail assembly and the intake
manifold.
13. Tag and disengage all necessary electrical connectors.
14. If equipped with A/C, remove the air compressor support bracket.
15. Disconnect the PCV lines. One is located on the upper intake manifold. The
second is located at the left rocker cover and the lower intake stud.
16. Remove the throttle body assembly and remove the EGR valve assembly from the
upper intake manifold. For details regarding throttle body removal, please refer to
Section 5 of this manual.
17. Remove the attaching nut, then remove the wiring retainer bracket located at the
left front of the intake manifold and set aside with the spark plug wires.
18. Remove the upper intake manifold attaching bolts/studs. Remove the upper intake
manifold and gasket.
Стр . 52 из 211
18.11.2005 file://C:\DOCUME~1\SILENT~1\LOCALS~1\Temp\trsHIPBC.htm