Ford Taurus, Руководство пользователя

Страница: 385 / 2156

23. Apply a dab of Gasket and Trim Adhesive D7AZ-19B508-B, or equivalent adhesive,
to each cylinder head mating surface. Press the new intake manifold gaskets into
place, using locating pins as necessary to aid in assembly alignment.
24.
Apply a
1
/
8
in. (3-4mm) bead of silicone sealer at each corner where the cylinder
head joins the cylinder block.
25. Install the front and rear intake manifold end seals.
26. Carefully lower the intake manifold into position on cylinder block and cylinder
heads. Use locating pins as necessary to guide the manifold.
27. Install the retaining bolts and stud bolts in their original locations.
28. For vehicles through 1991, torque the retaining bolts in numerical sequence to the
following specifications in 3 steps:
1. Step 1: 8 ft. lbs. (11 Nm)
2. Step 2: 15 ft. lbs. (20 Nm)
3. Step 3: 24 ft. lbs. (32 Nm)
29. For 1992-93 vehicles torque the retaining bolts in numerical sequence to the
following specifications in 2 steps:
1. Step 1: 8 ft. lbs. (11 Nm)
2. Step 2: 15 ft. lbs. (20 Nm)
30. Connect the rear PCV line to upper intake tube, then install the front PCV tube so
the mounting bracket sits over the lower intake stud.
31. Install the injectors and fuel rail assembly. Tighten the screws to 6-8 ft. lbs. (8-11
Nm).
32. Position the upper intake gasket and manifold on top of the lower intake. Use
locating pins to secure position of gasket between manifolds.
33. Install bolts and studs in their original locations. Tighten the 4 center bolts, then
tighten the end bolts. Repeat Steps 28 or 29 depending on vehicle year application.
34. Install the EGR valve assembly on the manifold. Tighten the attaching bolt to 15-22
ft. lbs. (20-30 Nm).
35. Install the throttle body. Cross-tighten the retaining nuts to 15-22 ft. lbs. (20-30
Nm).
36. Connect the rear PCV line at PCV valve and upper intake manifold connections. If
equipped with A/C, install the compressor support bracket. Tighten the retaining
fasteners to 15-22 ft. lbs. (20-30 Nm).
37. Engage all electrical connectors and vacuum hoses.
38. Connect the heater tube hose to the heater elbow. Position the heater tube support
bracket and tighten attaching nut to 15-22 ft. lbs. (20-30 Nm). Tighten the hose
clamp at the heater elbow securely.
39. Connect the heater hose to the rear of the heater tube, then tighten the hose
clamp.
40. Connect the coolant bypass and upper radiator hoses and tighten the hose clamps
securely.
41. Connect the fuel line(s) at injector fuel rail assembly, then connect the flexible fuel
lines to the steel lines.
42. Position the accelerator cable mounting bracket, then install and tighten the
retaining bolts to 15-22 ft. lbs. (20-30 Nm).
43. Connect the speed control cable, if equipped. Connect the transaxle linkage at the
Стр . 55 из 211
18.11.2005 file://C:\DOCUME~1\SILENT~1\LOCALS~1\Temp\trsHIPBC.htm