Ford Taurus, Руководство пользователя

Страница: 390 / 2156

REMOVAL & INSTALLATION
2.5L Engine
1. Disconnect the negative battery cable.
2. Drain the cooling system.
3. Remove the accelerator cable and, if equipped, the cruise control cable.
4. Remove air cleaner assembly and heat stove tube at the heat shield.
5. Identify, tag and disengage all necessary vacuum lines and electrical connections.
6. Disconnect the exhaust pipe-to-exhaust manifold retaining nuts.
7. Remove exhaust manifold heat shroud. Disengage the oxygen sensor wire at the
connector.
8. Disconnect the fuel supply and return lines.
9. As required on vehicles before 1990, disconnect the thermactor check valve hose
at tube assembly, remove bracket-to-EGR valve attaching nuts and disconnect
water inlet tube at intake manifold.
10. Disconnect EGR tube from the EGR valve.
11. Remove the intake manifold. For details regarding intake manifold removal, please
refer to the procedure located earlier in this section.
12. Remove the exhaust manifold retaining nuts, then remove the exhaust manifold
from the vehicle.
Click to enlarge
To install:
13. Position the exhaust manifold to the cylinder head using guide bolts in holes 2 and
3.
14. Install the remaining attaching bolts.
15. Tighten the attaching bolts until snug, then remove guide bolts and install
Exhaust manifold and bolt tightening sequence-2.5L engine
Стр . 60 из 211
18.11.2005 file://C:\DOCUME~1\SILENT~1\LOCALS~1\Temp\trsHIPBC.htm