Ford Taurus, Руководство пользователя

Страница: 348 / 2156

1. Remove the lower damper bolt from the right side of the engine.
2. Raise the vehicle and support it safely.
3. Place a jack and a wood block in a suitable place under the engine.
4. Remove the roll damper-to-engine retaining nuts and remove the roll damper.
5. Raise the engine enough to unload the insulator.
6. Remove the 2 through-bolts and remove the insulators from the engine bracket.
7. Installation is the reverse of the removal procedure. Tighten the insulator-to-
engine bracket bolts to 40-55 ft. lbs. (54-75 Nm). Tighten the insulator-to-frame
nuts to 50-70 ft. lbs. (68-95 Nm). Tighten the roll damper retaining nuts to 40-55 ft.
lbs. (54-75 Nm). Tighten the engine damper-to-engine bolt to 40-55 ft. lbs. (54-75
Nm).
LEFT ENGINE INSULATOR AND SUPPORT ASSEMBLY
1. Remove the bolt retaining the roll damper to the lower damper bracket and place
the damper shaft aside.
2. Remove the back-up light switch and the energy management bracket.
3. Raise the vehicle and support it with jackstands under the vehicle body, allowing
the subframe to hang.
4. Remove the left tire and wheel assembly.
5. Place a jack and wood block under the transaxle.
6. Remove the nuts retaining the lower damper bracket to the engine mount and the
bolts retaining the insulator to the transaxle and subframe.
7. Raise the transaxle with the jack enough to unload the insulator.
8. Remove the insulator and lower damper bracket.
9. Installation is the reverse of the removal procedure. Tighten the damper bracket-
to-insulator nuts to 40-55 ft. lbs. (54-75 Nm) and the insulator-to-transaxle bolts to
70-95 ft. lbs. (95-139 Nm). Tighten the insulator-to-frame bolts to 60-85 ft. lbs. (81-
115 Nm) and the damper to damper bracket bolt to 40-55 ft. lbs. (54-75 Nm).
3.8L Engine
RIGHT FRONT ENGINE INSULATOR
1. Disconnect the negative battery cable. Remove the air conditioning compressor-
to-engine mounting bracket mounting bolts and position the compressor to the
side. Do not discharge the air conditioning system.
2. Raise the vehicle and support safely.
3. Remove the nut attaching the engine mount to the air conditioning compressor
bracket.
4. Temporarily attach the air conditioning compressor to the mounting bracket with
the 2 lower bolts.
5. Position a jack and wood block in a convenient location under the engine block.
6. Remove the upper and lower nuts attaching the right front and left rear insulators
to the frame.
7. Raise the engine with the jack enough to relieve the load on the insulator.
8. Remove the insulator assembly. Remove the heat shield from the insulator.
Стр . 18 из 211
18.11.2005 file://C:\DOCUME~1\SILENT~1\LOCALS~1\Temp\trsHIPBC.htm