Ford Taurus, Руководство пользователя

Страница: 342 / 2156

33. Disconnect the 4 dual converter/Y pipe-to-exhaust manifold retaining bolts.
34. Remove the starter motor assembly. For details, please refer to the procedure
located earlier in this section.
35. Remove the lower transaxle-to-engine retaining bolts.
36. Remove the front engine mount-to-front subframe retaining nuts.
37. Remove the crankshaft vibration damper and pulley assembly.
38. Carefully lower the vehicle, then remove the upper transaxle-to-engine retaining
bolts.
39. Install engine lifting bracket D89L-6001-A or equivalent, according to
manufacturer's instructions.
40. Position Rotunda Hi-Lift Jack 014-00210, or an equivalent floor jack under the
transaxle.
41. Position Rotunda Three Bar Engine Support 014-00750 or equivalent, then raise
the transaxle assembly slightly and remove the engine assembly from the vehicle.
To install:
42. Position the engine assembly in the vehicle.
43. Install the upper transaxle-to-engine bolts, then remove the floor jack and engine
lifting equipment.
44. Raise and safely support the vehicle.
45. Install the crankshaft damper and pulley assembly. Tighten the retaining bolt to
112-127 ft. lbs. (152-172 Nm).
46. Install the front engine mount-to-front subframe nuts.
47. Install the lower transaxle-to-engine retaining bolts. Tighten the bolts to 25-35 ft.
lbs. (34-47 Nm).
48. Install the starter motor assembly. For details, please refer to the procedure
located earlier in this section.
49. Install the 4 dual converter Y pipe-to-exhaust manifold retaining nuts, then tighten
them to 20-35 ft. lbs. (27-47 Nm).
50. Apply anti-seize compound to the threads, then install the heated oxygen sensor.
Tighten the sensor to 27-33 ft. lbs. (37-45 Nm).
51. Install the right-side halfshaft to the transaxle, then connect the front axle bearing
bracket the cylinder block. Tighten the retaining bolts to 30-47 ft. lbs. (40-64 Nm).
52. Connect the right-side lower ball joint, tie rod end and the front stabilizer bar.
53. Connect the low oil level sensor, then install the wheel and tire assemblies.
Tighten the wheel lug nuts to 85-105 ft. lbs. (115-142 Nm).
54. Install the oil filter, then install the oil drain plug and tighten to 15-24 ft. lbs. (20-33
Nm).
55. Carefully lower the vehicle.
56. Install the A/C compressor and mounting bracket assembly, then tighten to 27-41
ft. lbs. (36-55 Nm). Connect the A/C manifold and tube.
57. Install the alternator assembly and tighten the retaining bolts to 36-53 ft. lbs. (49-72
Nm).
58. Install the suction accumulator/drier and the A/C accumulator bracket assembly,
Стр . 12 из 211
18.11.2005 file://C:\DOCUME~1\SILENT~1\LOCALS~1\Temp\trsHIPBC.htm