Ford Taurus, Руководство пользователя

Страница: 394 / 2156

and install it on the new manifold.
10. Position the exhaust manifold on the cylinder head, then install the retaining bolts.
Tighten the retaining bolts to 15-22 ft. lbs. (20-30 Nm).
11. Raise and safely support the vehicle.
12. Connect the dual converter Y-pipe to the exhaust manifold. Tighten the retaining
nuts to 25-34 ft. lbs. (34-47Nm).
13. If removed, install the water bypass tube, then tighten the retaining nut to 15-22 ft.
lbs. (20-30 Nm).
14. Connect the EGR valve-to-exhaust manifold tube to the exhaust manifold, then
tighten to 26-48 ft. lbs. (35-65 Nm).
15. Connect the PFE or DPFE hose(s), then connect the negative battery cable.
16. Start the engine and check for exhaust and/or coolant leaks.
3.0L SHO Engine
Always use new gaskets when installing the exhaust manifolds.
LEFT SIDE
1. Disconnect the negative battery cable.
2. Remove the oil level indicator tube support bracket.
3. Remove the power steering pressure and return hoses.
4. Remove the exhaust manifold-to-dual converter Y-pipe retaining nuts.
5. Remove the heat shield retaining bolts.
6. Remove the exhaust manifold retaining nuts, then remove the exhaust manifold.
To install:
7. Clean all exhaust manifold, cylinder head and Y-pipe mating surfaces, then lightly
oil all bolt and stud threads.
8. Position the exhaust manifold on the cylinder head, using a new gasket, then
install the retaining nuts. Tighten the retaining nuts 26-38 ft. lbs. (35-52 Nm).
9. Install the heat shield retaining bolts, then tighten the bolts to 11-17 ft. lbs. (15-23
Nm).
10. Connect the dual converter Y-pipe to the exhaust manifold. Tighten the retaining
nuts to 15-24 ft. lbs. (20-32 Nm).
11. Connect the power steering pressure and return hoses.
12. Install the oil level indicator tube support bracket.
13. Connect the negative battery cable.
RIGHT SIDE
1. Disconnect the negative battery cable.
2. Remove the right hand cylinder head. For details regarding cylinder head removal,
please see the procedure located later in this Section.
3. Remove the heat shield retaining bolts.
Стр . 64 из 211
18.11.2005 file://C:\DOCUME~1\SILENT~1\LOCALS~1\Temp\trsHIPBC.htm