Ford Taurus, Руководство пользователя

Страница: 388 / 2156

15. Disconnect the heater water hose from the lower intake manifold, then disconnect
the heater water outlet tube from the lower intake manifold.
16. Remove the fuel injectors and the fuel injection supply manifold.
The lower intake manifold is secured at each corner with sealer. To break
the seal you may have to carefully pry the front of the manifold with a
suitable prybar. Be careful not to damage the machined surfaces.
17. Remove the lower intake manifold retaining bolts. then remove the lower intake
manifold. Remove the manifold gasket, and end seals and discard them.
Click to enlarge
To install:
When installing the upper and/or lower intake manifold(s), ALWAYS use
a new gasket.
18. Lightly oil all retaining bolt and stud bolt threads before installation.
When using silicone rubber sealer, assembly must occur within 15
minutes of sealer application. After 15 minutes, the sealer may start to
set-up, and lose its sealing effectiveness.
19. Use a suitable solvent to clean the gasket mating surfaces. The mating surfaces of
the lower intake manifold, cylinder head and cylinder block should be clean and
free of old gasketing material.
20. Before applying sealer, clean the sealing surfaces of the cylinder heads and the
lower intake manifold with Metal Surface Cleaner F4AZ-19A536-RA or equivalent,
to remove all residues that may affect the sealer's ability to adhere.
21. Apply a dab of Gasket and Trim Adhesive D7AZ-19B508 or equivalent, to each
Lower intake manifold and gasket and seal location-1995 3.8L engine shown
Стр . 58 из 211
18.11.2005 file://C:\DOCUME~1\SILENT~1\LOCALS~1\Temp\trsHIPBC.htm