Fondital FORMENTERA KC 24, Инструкция по эксплуатации

Страница: 67 / 96

________________________________________________________________________________
67
AST 14 C 257/00
Heat dissipation from the collector
If the solar tank heater reaches the set temperature, this function prevents the solar
collectors from stagnating for a long time, which may cause them high thermal
stress. For this reason, the PS solar pump is reactivated according to the following
logic:
Tscs > (P22-10°C)
and
Tsvs ” 95°C
and
Tscs ” (P22 – 5°C)
The function disactivates when the PS switches off at the following conditions:
Tscs ” (P22-12°C)
or
Tsvs • 95°C
or
Tscs > (P22)
Important. This function is only active if the DHW+HEATING, HEATING ONLY or
DHW ONLY operating mode is set on the b oiler. It is not active in the event of
failure involving the SVS solar valve prob e.
Tank heater cooling function
This function cools the tank heater to the set-point value, by dissipating any
excessive heat in the tank heater on the solar collector. This only occurs if the solar
tank heater has exceeded the set-point temperature following activation of the heat
dissipation function.
If the remote control is not connected, the tank heater cooling function is always
active. Otherwise, it is only enabled from 00.00am to 6.00am.
Activation of the PSOL solar pump for tank heater cooling:
Tsvs > P19+2°C
and
Tscs < Tsb s-¨ T ON (P20)
This function deactivates when the PSOL switches off under the following
conditions:
Tsb s < P19
or
Tscs > Tsvs-¨ T OFF (P21)
Important. This function is only active if the DHW+HEATING, HEATING ONLY or
DHW ONLY operating mode is set on the b oiler. It is not active in the event of
failure involving the SVS solar valve prob e.
Set parameter P26 to 1 to activate this function,
Solar collector anti-freeze function
When the temperature read by the collector probe is below 4°C, the PSOL solar
pump activates until the temperature reaches 5°C.