FMS BKS601C, Веб-руководство

Страница: 50 / 52

Operating Manual BKS601C
50
15 Trouble Shooting
Error Cause Corrective action
Controller guides web
edge immediately out
of the sensor Control mode was
wrongly parametrized Set parameter Control mode
according to the sensor position
Parameter Output
config. is set wrongly
Change parameter Output config.
Sensor signal was
wrongly parametrized Set service parameters Sensor
covered, Sensor uncovered,
Sensor range
correct
No edge/line found
Edge/line missing
The sensor is not
adjusted properly Adjust sensor more accurately
Steering frame does
not move No sensor signal. Sensor
is not correctly
connected Connect sensor correctly
according to wiring diagram and
installation guide
No signal; cable break Replace cable or send sensor to
FMS
No signal; sensor defect Send sensor to FMS; use other
sensor
Steering device not
correctly connected Connect steering device correctly
according to wiring diagram and
installation guide
Steering device moves
in the wrong direction Service parameter Motor
config. is set wrongly
Change service parameter motor
config.
Sensor signal wrongly
parametrized Set service parameters Sensor
covered, Sensor uncovered,
Sensor range
correct
Motors of the linear
units don’t move
Motors are not correctly
connected Connect motors correctly
referring to wiring table
Hardware error Contact FMS customer service
Linear units don’t
move properly to its
reference positions Limit switches are
connected wrongly Connect limit switches correctly
referring to wiring diagram
Dig. outputs do not
work Wiring error Check wiring of the dig. outputs
(ref. to wiring diagram)
Grounding not
connected Connect Grounding wire to the
PE terminal (ref. to wiring
diagram)
Sub-Board
missing
contact FMS AG
One or more sub-boards
are missing or are not
detected Check if sub-boards are
connected correctly (ref. to „15.1
Additional Setting Elements “)
Contact FMS customer service