Website
24
Elysium
EL18
4.
Test.
On the custom failsafe setup interface, to set a separate channel, you can
also click of the corresponding CH.
7.3.6 External RF
Set the model channel range, radio frequency protocol, failsafe mode,
refresh rate, and PPM frame rate of the external RF module.
EdgeTX supports the use of multiple RF modules. Each RF module supports
different communication protocols and setup methods. For specific
information, refer to the instruction manual of the corresponding RF
module.
If another RF module is used, it should match a receiver that is compatible
with the RF module. In this way, the binding can be completed.
In the setup of the internal RF or external RF, the delay can be properly
reduced by setup the appropriate channel range, PPM frame and other
parameters.
7.3.7 Trainer
This function is used to set the master/slave mode of the trainer port. Four
modes are available for selection.
When the "Master/Jack" is selected, the transmitter outputs trainer control
signals to the model as the trainer mode, and student control signals are
input from the audio jack.
When the "Slave/Jack" is selected, control signals of this transmitter are
output to the trainer port from the audio jack. When the transmitter is
connected to the simulator with a dongle, you need to select this option.
In this mode, you can set the channel range and PPM frame in the same
way as the RF setup.
In the PPM frame setup options, you can set the frame length, pulse width
and signal type respectively.
7.3.8 Timer1
Name
Name the timer with up to 8 characters.
Mode
Set the mode and switch for triggering the timer. You can set 6 groups of
modes in total. A combination of different controls is used to control the
start and stop of the timer. There are up-timer and down-timer.
Different timer modes can meet various flight condition requirements.
"OFF" Switch off the timer.
"ON" After the ON switch of the timer is triggered, it is not affected by
