Website
23
Type
Select the transmitter and receiver connection parameters. There are
classic and enhanced receivers in Flysky 3rd generation receivers. For the
two types of receivers, you need to select the appropriate type.
"FCC or CE"
Set the transmit power of the current transmitter. Legal
regulations vary with countries/regions. Please choose the appropriate
transmitter power according to the relevant legal information.
"Classic 18ch
" Adapt to AFHDS 3 Classic receivers, such as FTr10/FTr4/
FTr16S. There are 18 channels for communications.
"Classic 10ch"
Adapt to AFHDS 3 Classic receivers. There are 10
channels for communications.
"Routine 18ch
" Bind the Enhanced receivers, with a moderate
communication distance. There are 18 channels for communications.
"Fast 8ch"
Bind the Enhanced receivers, with fast communication speed
in a short distance. There are 8 channels for communications.
"Lora 12ch"
Bind the Enhanced receivers, with super anti-interference
and moderate communication distance. There are 12 channels for
communications.
"
Modules Option
" Set PWM frequency, as well as the output signal type
of the receiver, namely one of PWM/PPM/SBUS/i-BUS2/iBUS IN/iBUS
OUT.
Channel Range
You can set the number of receiver output channels. By default, it is CH1-
CH14. You can set the number of channels required by the model.
Receiver
Set the receiver ID.
(To be updated...)
Bind
Click "Bind" to make the transmitter enter the binding state. The
"Binding" can be displayed in the "Module Status" state, indicating that
the transmitter enters the binding state.
Failsafe Mode
used to set the output channel value of the receiver after the receiver
loses the signals. Five states can be set: "Not set", "Hold", "Custom", "No
pulses", and "Receiver".
"Custom" Users can set the failsafe preset output value according to
the failsafe output requirement of the model. On the setup interface, the
blue travel bar indicates the output value of the corresponding position
of the current control, and the red travel bar indicates the output value
of the failsafe already set.
Steps:
1.
Click "Custom" to set it to failsafe, then click "Set" .
2.
Toggle the stick and control to the preset value position.
3.
Click "Import all values of current channel". The transmitter will use
this value as the failsafe output value