Website
28
Elysium
EL18
7.3.14 HELI Setup
(To be updated...)
7.3.16 Inputs
It is used to assign serial number, name, switch, curve, trim, and offset
for each input. The serial number in the input setup does not represent
the actual output channel serial number. The parameters in the input
setup are set for each input source stick, toggle switch, knob, trim,
button, and logic switch. The parameters set for each input source may
be brought into the mixer that references the input for the calculation.
By setup each input to be referenced, it is more convenient for the use
by the mixes in future.
Input name
To set the name of the channel, with up to 4 characters.
7.3.15 Flight Modes
To cope with different flight conditions or special flight tasks, you need
to set different flight modes, to achieve some precise movements, or fast
rolls. Therefore, the stick rate and travel requirements vary with flight
modes.
With this function, you can set the name of each mode, ON switch, trim
values of different modes, and the entry and exit time in the switching
transition of each flight mode, respectively. Up to 8 flight modes can be
set.
Take FM1 mode as an example.
Name
To set the name of the current flight mode. The name contains up to 10
characters.
Switch
To set the switch to enable the current mode. It can be set to gear
switch, trim switch, logic switch, etc.
For example, set the throttle trim button to toggle upwards as a switch,
select "SB-", and toggle SWB in the middle position to enable the flight
mode.
Fade in
(To be updated...)
Fade out
(To be updated...)
Trim
(To be updated...)
