Website
13
4.3 RF Module Adapter Installation
Two RF module adapters are included with the transmitter to match different RF module. To install the suitable RF
module adapter according to the actual RF module.
The EL18 is able to switch stick functions as needed. When the EL18 is shipped from the factory the left stick is set up for
throttle with non self-centering. Follow the steps below to set right stick to non self-centering if the right stick is going to
set up for throttle.
Follow the steps below to install
the RF adapter.
1.
There are 4 screw holes and
one port at the back of the
transmitter, shown as below.
The screw holes are used to
fix the RF module adapter to
the transmitter and the port is
used to connect the interface
of the RF module adapter.
2.
Align the holes of the RF
module adapter up to the
holes on the transmitter, and
make sure the interface of the
RF module adapter insert the
port entirely, then tighten the
screws.
FGPZ04 adapter
FGPZ05 adapter
4.4 Left and Right Gimbal Swap
1.
Remove the 2 hand grips and switch pads, then
remove all 10 screws on the bottom of the transmitter
apart from the screws in the finger grips. Lift gently to
pull the cover apart.
2.
Left and right gimbals shown below for clarity.
Left
Right
Pad
Square hole
Attention
Don't pull the front cover and
back cover too far apart to avoid
damaging cables.
Do not
remove this
screw
Pull
the
back
cover
gently
Pry
open
RX
GND
VCC
S.port
PPM/TX
