Fluke Versiv, Руководство пользователя

Страница: 168 / 260

Versiv Cabling Certification Product Family
Users Manual
154
Test Type
(cont.)
FaultMap
: The FaultMap test can show connections that
do not show on the OTDR EventMap and connections that
are poor because they have high reflectance. See “The
FaultMap Test” on page 174.
SmartLoop OTDR (Auto)
and
SmartLoop OTDR (Manual)
:
The SmartLoop test lets you connect the far ends of the
two fibers in a link so that one OTDR test gives you results
for both fibers. The Auto and Manual settings operate the
same as for the OTDR test. See “The SmartLoop Test” on
page 180.
Manual OTDR
Settings
This item shows only if you select
Manual OTDR
or
SmartLoop OTDR (Manual)
for the
Test Type
. Manual
OTDR mode lets you select settings to control the qualities
of the trace. See the Technical Reference Handbook.
Bi-Directional
This setting shows only if you select
SmartLoop OTDR
(Auto)
or
SmartLoop OTDR (Manual)
for the
Test Type
.
Off
: The tester does the SmartLoop test in only one
direction.
On
: The tester does the SmartLoop test in both directions.
See “The SmartLoop Test” on page 180.
Launch
Compensation
Tap the control to turn the launch compensation function
on or off. See“About Launch and Tail Cords” on page 156.
Wavelength
Select the wavelengths you want to use. You can do tests
at one or all of the wavelengths supported by the module
you selected.
Fiber Type
Select a fiber type that is correct for the type you will test.
To see a different group of fiber types, tap
MORE
, then
tap a group.
Note
Select a fiber type before you select a test limit
and wavelengths. The tester shows only the test
limits and wavelengths that are applicable to the
selected fiber type.
Table 7. Settings for OTDR Tests (continued)