Fluke Versiv, Руководство пользователя

Страница: 136 / 260

Versiv Cabling Certification Product Family
Users Manual
122
1-7
To enter the length of the test reference cords you will add to
connect to the link, tap
TRC LENGTH
on the
SET REFERENCE
screen. The length you enter does not change the test results.
The tester saves the length with the results to meet TIA
reporting requirements.
1-8
Tap
SET REFERENCE
. If you did not use the connection wizard,
go to step 3.
Step 2: Measure the Loss of the Test Reference Cord You
Will Add

Caution
If you disconnected a test reference cord from the
output of the tester or remote, you must set the
reference again to make sure your measurements
are reliable.
2-1
On the
SET REFERENCE
screen, when the reference procedure
is completed, tap
NEXT
.
2-2
Disconnect the test reference cords from the INPUT ports on
the tester and remote, then use test reference cords and
adapters to make the connections to verify the TRCs, as shown
on the screen and in Figure 47.
2-3
Tap
TRC VERIFICATION
. The tester measures and saves the loss
of the test reference cords you added. The IDs for these results
start with “TRC”, show the date and time of the test, and have
an for the test result.
The tester shows a warning if the loss of a TRC is more than
these limits:

Maximum loss for multimode TRCs
: 0.15 dB

Maximum loss for singlemode TRCs
: 0.25 dB
If the tester shows a warning, clean and inspect the
connectors on the TRCs in the path that has too much loss,
then set the reference and do the TRC verification again.