Fluke Versiv, Руководство пользователя

Страница: 126 / 260

Versiv Cabling Certification Product Family
Users Manual
112
Test Limit
Select the correct test limit for the job. To see a different
group of limits, tap
MORE
, then tap the name of a
group. To make a custom limit, tap
Custom
in the
Limit
Groups
list. See the Technical Reference Handbook.
Reference
Method
On the
No. of Connectors/Splices
screen, set the number
of jumpers you will use in each fiber path when you set
the reference. The dotted lines in the diagram on the
screen show you which parts of the link are included in
the test results.
The number of jumpers you use has these effects on loss
measurements:
1 Jumper
: Loss measurements include the connections at
both ends of the link. The figures in this manual show
1
Jumper
connections.
2 Jumper
: Loss measurements include one connection at
one end of the link.
3 Jumper
: Loss measurements do not include the
connections at the ends of the link. The tester measures
only the loss of the fiber.
This setting does not change the loss measurements, but
it can change the
PASS
/
FAIL
result for test limits that use
a calculated loss limit. For all test limits, the tester saves
this setting to show the reference method you used.

Caution
Most cable manufacturers will give you a
warranty on a fiber installation only if you use
the 1 Jumper reference method when you
certify the installation.
Note
Different standards use different names for the
three methods. See Appendix A.
Connector Type
Select the type of connector, such as SC or LC, used in the
cabling. The tester saves this setting to record the type of
connector you used. This setting does not change your
test results or any of the diagrams that the tester shows.
If the correct type is not in the list, select
General
.
Table 6. Settings for Fiber Tests (continued)