FLENDER LOHER DYNAVERT L05 Series, Инструкции по вводу в эксплуатацию и техническому обслуживанию

Страница: 22 / 66

Instruction
manual DYNAVERT
®
L05
22 Stand/ issue: 25.07.03 4BS0516DE-EN/011
3.6 Menues
All parameters are arranged in a menu structure. In order to reduce the number of parameters shown on the LCD-
display, they are classified into the categories “
Commissioning ” (“Commis.”), “ Standard ” (“Stand.”) and “ Expert ”
(“Expert”), and they appear only when the appropriate setting was made in submenu “Operation ” / parameter “ Menü ”.
Commissioning: Shows all parameters required for standard commissioning and diagnostic
indications. The parameters are preset accordingly in the factory!
Standard: Shows further operational values in addition to the commissioning parameters,
e.g. for trouble shooting or remote diagnosis.
Expert: Indicates all parameters of the frequency inverter. Do not change the
parameters (except after consultation with Loher!).
Below we show the menu-tree for all commissioning parameters. A complete list of all parameters is shown in the annex
of this commissioning instruction.
3.6.1 Information menu
I-DRIVE DATA
Display-text Menu Description Unit
v-travel
Commis.
Aktual travelling speed (m/s)
Accel.
Commis.
Aktual acceleration (m/s
2
)
BrkDis(S)
Commis.
Act. braking distance stop-switch (cm)
Speed(A)
Commis.
Act. braking speed stop-switch (m/s)
n-motor
Commis.
Motor speed rpm)
I-motor
Commis.
Motor current (A)
Driv.ord.
Commis.
Aktual drive order ( ... )
1)
Travel
Commis.
Aktual travel ( ... )
1)
I-MIN.BRAKE.DIST.
Display-text Menu Description Unit
BrkDis 3
Commis.
Braking distance out of v3 (cm)
I-MEMORY
2)
01:
Commis.
Event memory 1 (fault message)
02:
Commis.
Event memory 2 dto.
...
Commis.
Event memory n dto.
64:
Commis.
Event memory 64 dto.
I-INVERTER DATA
Op.-source
Commis.
Operation source (“Termin” / “RS485”)
Comm. fault
Commis.
Relay contact common fault (“Open c.” / ”cls. c.”)
Remark: 1) Poss. travel commands: “ none ”, “v 1 ” – “ v8 ”, “ v Posi ”, “ floor ”, “ variable l”,
“ Rev. v1 ” – “ Rev. v3 ”, “ adjus t”, “ revision ”, “ Rev. v Posi ”, “ readjust ”
2) Complete representation of the event memory is shown under 5.5