FlavorShot AC-FS5, Руководство по обслуживанию

Страница: 48 / 56

48
VI TROUBLESHOOTING GUIDE (FlavorShot 5)
Problem Action
No power at the plug
1. Check AC outlet for 120 VAC.
2. Have a qualified person check the fuse box or
circuit breaker to restore power to the circuit.
Dispenser will not turn
on 1. Make sure the power cord is plugged in to an active
power source.
2. Check the ON/OFF switch (See page 25) on the left
side of the dispenser to make sure it is ON.
3. Check to make sure the circuit breaker on the lower
left side of the dispenser has not tripped out. If it
has, turn the power switch OFF, reset the circuit
breaker by gently pushing it in once to reset it - push
in at the top of the breaker until no white is showing.
Then, turn the power back ON.
Dispenser will not
dispense flavor
1. Make sure the power cord is plugged in to an active
power source.
2. Make sure there is flavor product in the tanks.
3. Make sure the dispensing tubes from the flavor
tanks are clear of blockage, with no twists or kinks
and are not pinched off.
4. Make sure the dispensing tube block is clean.
5. Prime the tank pump. (See page 9)
6. Turn OFF the dispenser, wait 10 seconds, then turn
the dispenser back ON.
(This resets the microcontroller.)
7. Check to ensure the LCD window displays
“Wait …..” If the symbol ^ appears anywhere in
this row of dots, it indicates that pump has failed to
register.
For example, “Wait ..^..” Indicates pump 3 has not
registered and pump 3 will not dispense flavor. If a
^ appears, then remove the back of the dispenser
and verify the connections to the pumps are
seated properly on the center bottom of the pump
driver circuit board.
If two pumps have the same address, the display
will show 2 ^s, e.g. ^ ^, even though only one
pump has the problem. To correct, re-address one
pump. If that does not fix the problem, re-address
the other pump.
8. If the motor is working but the plunger does not