FlavorShot AC-FS5, Руководство по обслуживанию

Страница: 28 / 56

28
8. Electrical Cord replacement
To Replace the Electrical Cord:
1. Disconnect the AC power supply.
2. Remove the back panel by removing its 10 screws.
3. Using pliers, depress the plastic wire strain relief grommet where the cord
enters the stainless steel body of the dispenser and turn it to the right.
4. Slide the cord out.
5. Remove the ground wire from the cord and from the grounding post.
6. Cut and splice the live and neutral wires from the AC power cord.
7. Reconnect with appropriate UL-approved marrettes. Do
not use electrical
tape.
9. Power Supply removal (See General Assembly View, p 45)
To Remove the Power Supply:
1. Remove the back panel by removing its 8 screws.
2. Disconnect the 2 connectors on the right and left sides of the power supply
board at the top of the dispenser, by pulling them out:
6-pin connector on the right
3-pin connector on the left
3. Disconnect the primary grounding wire (green) from the lower left corner of
the board.
4. Remove the 4 corner screws securing the power supply plate to the board.
5. Remove the secondary ground wire (black) on the right, held in place by a
screw securing the power supply to the board.
6. Remove the power supply.
AC Power Cord
Power Supply