FlavorShot AC-FS5, Руководство по обслуживанию

Страница: 22 / 56

22
dispenser will operate again.
•
IR will be displayed in the LCD window while the download is underway.
•
It takes approximately 1 minute for the program download procedure to
be completed – press the IRPD button throughout the procedure. Do not
interrupt the program download.
•
The program download is in 2 segments. The red Indicator Lights on the
size buttons illuminate during the download – the light on the middle (M)
button illuminates throughout. Next, the lights on the inner two buttons (S
and L) illuminate to indicate the first segment of the new program has
been downloaded. Finally, the lights on the outer two buttons (X and XL)
illuminate indicate the second segment of the program has been
downloaded.
•
The LCD window displays a WAIT message to indicate that it is re-
booting and that you should wait until the procedure is completed.
4. Once the reprogramming is complete, the system reboots automatically and
the LCD window returns to the display “Select Flavor”.
To Adjust Individual Dispense Amounts
(Alternative method)
1. Enter Program Mode: Press Prime and hold for 2 seconds.
Press Clean and hold for 2 seconds.
2. Select Flavor , or Modifier if applicable.
3. Select Size
4. Use Hidden Button 1 (UP) and Hidden Button 2 (DOWN) to adjust the
dispense amounts. Each adjust is 0.1 ml increase or decrease for amounts of
25.4 ml or less. For amounts of more than 25.4 ml, each increase or
decrease is 0.5 ml.
Program Mode: 2
Program Mode 2 is used only to reprogram factory settings and should
not be adjusted in the field. Adjustments could result in the dispenser not
functioning properly.
If the LCD displays “Program Mode: 2”, exit this mode by pressing the
Clean button. The dispenser should return to Program Mode: 1, and the LCD will
show “Program Mode: 1”. If it does not, contact the A. C. Dispensing Equipment
Inc. Technical Assistance Center at 1-888-777-9990 or 1-902-865-9602.