Flavor Burst TS 44BEV, Руководство пользователя

Страница: 71 / 100

70
5. Hold a large container under the spout.
Move the draw handle to the open position
to dispense product. Ensure the TS 44BEV
operates properly with all four syrup lines
dispensing in succession.
NOTE: IF THE SYSTEM SOUNDS A BEEP
AND FLAVORS CEASE TO FLOW, A
SERVING SIZE MAY HAVE ACCIDENTLY
BEEN SELECTED. REPEAT THESE STEPS,
PAYING PARTICULAR ATTENTION TO
STEP 3.
6. If a syrup line fails to operate when tested,
select that flavor on the Touchscreen and
draw the serving again to verify the syrup
pump is malfunctioning. See the
Troubleshooting section at
www.flavorburst.com or contact your local
distributor for help.
7. Repeat these instructions for Spout B to
verify the other four pumps are working
properly.
Draw Mode Options
The TS 44BEV system can be set for three
different draw modes. With the TS 44BEV
system, different draw modes can be set on
separate spouts.
The standard manual draw mode dispenses
flavors as long as the draw handle is open.
Flavor flows through the syrup line when the
draw handle is in the open (dispensing)
position. The flavor continues to flow until the
draw handle is closed. In this mode, the
operator can clear out the remaining flavors in
the spout and reduce carryover in the next
serving by topping off the serving (quickly
opening and closing the spout over the serving)
or dispensing a small amount of plain product
into a cup to dispose of later.
The timed serving size draw
mode eliminates
the need for topping off the serving. Small,
medium, large and extra-large sizes are pre-
programmed to stop the flow of flavor after
product has dispensed for a specific time.
When the serving has reached its size limit,
flavor flow ceases and, shortly after, a beeping
sound alerts the operator to close the draw
handle. The brief time between the flavor shut-
off and the beeping sound allows unflavored
product to clear the remaining flavor through
the Blending Head, which greatly reduces
carryover issues. This application is also useful
for self-service operations in maintaining
consistent serving
The auto dispense draw mode is exclusively
designed for Frozen Carbonated Beverage
freezers and will not work on a non-FCB
freezer. The FCB freezer also requires a
special Flavor Burst Injector Assembly which is
not included standard with the TS 44BEV
system.