Flavor Burst TS 44BEV, Руководство пользователя

Страница: 41 / 100

40
Refilling the Sanitizer Tank
The Sanitizer Tank system provides approved
sanitizer solution to specific areas of the Flavor
Burst
®
system such as the Blending Head and
syrup lines during certain functions. In order to
utilize these clean-in-place functions, keep an
adequate supply of approved sanitizer solution
in the Sanitizer Tank at all times. The Sanitizer
Tank should be checked on a daily basis, but
only needs to be refilled if the supply is low.
1. Prepare approximately 3 gallons
(11.5 Liters) of approved sanitizer solution
according to manufacturer’s instructions.
2. Remove the hand pump from the Sanitizer
Tank and discard any remaining sanitizer.
3. Fill the Sanitizer Tank with the solution.
4. Reinstall the hand pump and tighten. Pump
air into the Sanitizer Tank with the handle to
prime the pump (approximately 10 strokes.)
NOTE:
NO PRESSURE IS NEEDED IN THE
TANK DURING NORMAL OPERATIONS.
Cleaning the Spout Adapter
The Spout Adapter does not require daily
cleaning under normal operating conditions.
Since the fitting is very tight, install the Adapter
with the freezer door removed. Therefore,
clean only as needed or when disassembling
the freezer door for cleaning (approximately
every 2 weeks). Replacement o-rings are
available in the Spare Parts Kit.
1. Mix approved detergent with warm water
according t
o manufacturer’s instructions.
Also, prepare approved sanitizer solution
according to manufacturer’s instructions.
2. Remove the Spout Adapter from the freezer
spout. Since the fitting is very tight, you may
need to use a small tool to pry the Adapter
from the door spout.
3. Remove the two black o-rings from the
Spout Adapter.
4. Clean the two o-rings and the Spout
Adapter with a small brush and detergent
water, and rinse thoroughly.