Flavor Burst TS 44BEV, Руководство пользователя

Страница: 65 / 100

64
Installing Flavors and Priming Syrup Lines
Each flavor for the TS 44BEV system is stored
inside a numbered syrup tray within the system
cabinet. Under normal operating conditions
flavors are installed as previous flavors are
emptied. However, you may change flavors
periodically as desired.
1. Mix approved detergent with warm water
according to manufacturer’s instructions.
Also prepare approved sanitizer solution
according to manufacturer’s instructions.
2. Remove each tray from the cabinet and
clean them with a single service towel and
detergent water. Rinse and dry thoroughly.
3. Select the syrup flavor you wish to use, then
place the bag on the table with the fitment
up and remove the dust cap.
4. Lifting up with the bag fitment, press the
center pin of the bag fitment valve and
gently press on the bag to release any
excess air.
5. Select a numbered tray to correspond with
the flavor you have chosen.
6. Place the tray up-side-down over the bag
and pull the fitment into the tray opening as
shown. The tray opening should slide
between the grooves of the bag fitment.
7. Holding the fitment in place, raise the open
end of the tray and flip the tray right side up.
As the tray is set back down, allow the bag
to settle in the tray.
8. Make sure the syrup bag is settled neatly
into the tray, and then install the loaded tray
into the cabinet.
9. Repeat Steps 1-8 to prepare and fill the rest
of the syrup trays.