Flavor Burst FB 80M Series, Руководство пользователя

Страница: 40 / 84

38
30. Carefully align the pins of the Syrup Line
Manifold with the Syrup Line Connector and
insert the end of the 9-Tube Assembly fully
into the Coupler. (See Figure 83.)
26178
Figure 83
31. Push the Coupler Nut into the Coupler Body
and rotate it clockwise. (See Figure 84.)
Figure 84
32. Replace the cap and hang the Assembly
onto the Accessory Hanging Bracket. (See
Figure 85.)
26186
Figure 85
33. Perform the entire DAILY CLOSING
PROCEDURES to clean and sanitize the
Injector System. This may also be done
during the Pump Flush Process as time
allows.
34. Perform the “Assembling the Injector
Assembly” and “Installing the Injector
System” of the DAILY OPENING
PROCEDURES.
35. Prime the syrup system as instructed in the
following section “Priming the Syrup
System.”
Priming the Syrup System
Priming the syrups is necessary when first
installing the flavors, after the Clean-In-Place
procedure, when an individual flavor or multiple
flavors remain idle for more than 72 hours, and
when changing flavors. Only the syrup lines
directly involved will require this process.
1. Select the number of the syrup line pump
you wish to prime.
2. Place a container under the Injector Head to
catch residual sanitizer solution and/or fresh
product to be dispensed and press PUMP
FLUSH to prime the syrup line. (See
Figure 86.)
26251
Figure 86
3. Once syrup flows consistently from the
Injector Head, press OFF to stop the syrup
flow.
NOTE:
THE PUMP FLUSH FUNCTION WILL
AUTOMATICALLY SHUT OFF AFTER 15
MINUTES IF YOU DO NOT PRESS THE “OFF”
KEY.
4. Repeat this entire process for each
additional syrup line.