Flavor Burst FB 80M Series, Руководство пользователя

Страница: 43 / 84

41
4. Clean the two o-rings, the white gasket and
the Injector Adapter with the Small Brush
and detergent water. Then rinse
thoroughly. (See Figure 97.)
Figure 97
5. Place the Injector Adapter, o-rings, and
white gasket in McD Sanitizer (HCS) and
soak for at least 5 minutes. (See
Figure 98.)
Figure 98
6. After soaking, remove each component
from the sanitizer solution and place them in
the drain tray to air dry. (See Figure 99.)
26096
Figure 99
7. Lubricate the black o-rings with Taylor HP
Lubricant and install them with the white
gasket in their respective positions on the
Injector Adapter. (See Figure 100.)
Figure 100
8. Clean the freezer door and spout according
to manufacturer’s instructions before
installing the Injector Adapter on the freezer
door.
9. Set the adapter on a flat, clean surface, and
then place the freezer door spout upright
onto the Adapter. Rock the freezer door
forward to snap the Adapter into place.
(See Figure 101.)
Figure 101
10. Return the freezer door to the freezer with
the Adapter attached.