Flavor Burst FB 80INT-08, Руководство пользователя

Страница: 57 / 85

56
4. Remove the protective adhesive tape from
the adhesive strip on the Bracket. (See
Figure 146.)
26181
Figure 146
5. Mount the Bracket to the desired area on
the freezer. (See Figure 147.)
26182
Figure 147
6. The Drive Motor hangs upside down in the
larger, square slot. The heads of the
mounting screws slide above the Bracket,
and the rest of the Motor hangs below. (See
Figure 148.)
26185
Figure 148
Installing the Internal Cabinet
The FB 80INT cabinet is designed to be
installed inside the Taylor C201 mobile cabinet.
Included is a modified back panel that replaces
the Taylor cabinet back panel to accommodate
Flavor Burst’s tubing and electronics wiring.
Follow the instructions below to set up the
Flavor Burst cabinet and connections.
Ensure the inside of the C201 mobile cabinet is
clean and ready for installation.
The following instructions and illustrations are
consistent with a left-side mounting of the
Injector Assembly. This is recommended for
Taylor C707 / C708 freezer as this is the side
with the intake vents which help prevent heating
of the 9-Tube Assembly. However, in cases
where left-side mounting is not possible, the
Injector Assembly and tubes may be installed
on the other side. Alternate instructions for a
right-side mounting are listed where applicable.
1. Remove the back panel and one of the side
panels from the Taylor C201 mobile cabinet.
(See Figure 149.)
26401
Figure 149
2. Remove the adhesive backing from the
foam supports and install one inside each
side support bar inside the Taylor cabinet.
(See Figure 150.)
26402
Figure 150