Flavor Burst FB 80INT-08, Руководство пользователя

Страница: 56 / 85

55
3. Swing the Casing cover outward. (See
Figure 141.)
26463
Figure 141
4. Carefully place the 9-Tube Assembly tube,
Drive Motor cable and Keypad cable inside
the Casing. Pull any excess tubes and
cables to the back of the freezer, allowing
enough slack in the front to comfortably
curve around to the Injector Assembly. (See
Figure 142.)
26464
Figure 142
5. Close the casing, taking care not to pinch
any of the lines or cables. (See Figure
143.)
26465
Figure 143
6. Install the screws to secure the Assembly.
(See Figure 144.)
26466
Figure 144
Mounting the Accessory Hanging Bracket
The Accessory Hanging Bracket is used to
suspend the Drive Motor while other parts of
the system have been removed for cleaning. It
can also be used to hold the 9-Tube Assembly
if the Casing Assembly is not used. The
Accessory Hanging Bracket should be mounted
in an accessible area 6 in. or more above the
Casing Assembly. This will allow enough room
for the Drive Motor to hang properly.
1. Mix approved detergent with warm water
according to manufacturer’s instructions.
2. Determine the approximate area where the
Bracket will be attached on the side of the
freezer. The Bracket should be attached on
the side the 9-Tube Assembly tubes wrap
around to the back of the freezer. It should
also be installed level just below the Keypad
Bracket.
3. Clean, rinse and dry thoroughly the area on
which the Bracket will be mounted using
detergent water, clean water, and single
service towels. (See Figure 145.)
Detergent
CLEAN
Water
RINSE
DRY
26180
Figure 145