Flavor Burst FB 80INT-08, Руководство пользователя

Страница: 42 / 85

41
6. Fill the Sanitizer Tank with approved
sanitizer. (See Figure 87.)
26243
Figure 87
NOTE: USE THE REMAINING SANITIZER
SOLUTION FOR MANUAL SANITIZING IN
THE CLEAN-IN-PLACE PROCEDURE, DAILY
OPENING PROCEDURES, OR DAILY
CLOSING PROCEDURES.
7. Reinstall the cap and tighten sufficiently.
Slide the Sanitizer Tank into the cabinet.
(See Figure 88.)
26244
Figure 88
8. Reconnect the sanitizer supply line to the
Sanitizer Tank. (See Figure 89.)
26245
Figure 89
Cleaning the Spout Adapter
The Spout Adapter does not require daily
cleaning under normal operating conditions.
Since the fitting is very tight, install the Adapter
with the freezer door removed. Therefore,
clean only as needed or when disassembling
the freezer door for cleaning (approximately
every 2 weeks). Replacement o-rings and
gasket are available in the Spare Parts Kit.
NOTE:
THE ADPT 8750A ADAPTER DOES
NOT INCLUDE A GASKET. IF THIS
ALTERNATE ADAPTER IS INSTALLED,
IGNORE REFERENCES TO THE GASKET
WHEN CLEANING THIS ADAPTER.
1. Mix approved detergent with warm water
according to manufacturer’s instructions.
Also, prepare approved sanitizer solution
according to manufacturer’s instructions.
2. Remove the Spout Adapter from the freezer
head. Since the fitting is very tight, you may
need to use a small tool to pry the Adapter
from the door spout. (See Figure 90.)
26130
Figure 90
3. Remove the two black o-rings and white
gasket from the Spout Adapter. (See
Figure 91.)
26131
Figure 91