Fischer Panda 6500 PMS, Руководство пользователя

Страница: 37 / 214

22.3.11 Grundlagen_deu.R01 - Kapitel/Chapter 3: Seite/Page 37
engine during the stand still. At the control unit a correspondent note „NO COOLING WATER“ has to be placed.
• Drain engine oil as required. Refill engine with conservation oil up to maximum at the oil dip stick.
• Drain diesel fuel from tank and refill with conservation mixture (90% diesel and 10% conservation oil - up to max).
Let engine run for 10 min.
• Remove v-belt as required and store packed at a dry place. Protect from UV radiation
• Disconnect battery.Sprinkle terminals with acid-free grease.
Attention! Cover alternator openings.
No cleaning fluids or preservative agents may enter the
alternator. Danger to destroy the alternator.
• Clean engine according to the manufacturer.
• Inject engine parts and v-belt pulleys with a preserving agent.
• Clean air filter housing and inject with a preserving agent.
• Sprinkle exhaust turbo charger (if existent) with conservation agent at intake and exhaust and close lines again.
Sprinkle preserving agent to the intake and exhaust lines than attach again.
• Remove valve cover and sprinkle the inside of the cover, shafts, springs, rocker lever etc. with preserving agent.
• Remove injectors and sprinkle the cylinder area with preserving agent. Keep the shut-off lever on the 0-position and
turn the engine by hand for several times. Screw in the injectors with new gaskets. Consider the torsional moments.
• Sprinkle slightly the radiator cap and tank lid and respectively the radiator cap at the expansion tank and reinstall.
• Close intake and exhaust openings (for example with tape or end caps).
• Drain sea water circuit.
• Close sea cock.
• Clean sea water filter.
• Dismount impeller and store.
Attention! Carry out a deconservation before recommissioning.
3.4.4.2 Arrangements after a long-term standstill (shutdown) / recommissioning (more
than 6 months):
• Check the charge of battery and recharge if necessary. Consider the specifications of the battery manufacturer.
• Check anti-freeze protection and level of the cooling water and refill if applicable.
• Drain engine oil. Renew oil filter and oil according specification.
• Remove preservation agent of the engine with petroleum.
• Degrease the v-belt pulleys and install v-belt correctly. Check v-belt tension!
• Disconnect turbocharger oilpressure line if existent and refill clean motor oil in pipe.
• Keep engine shut-off lever in 0-position and turn engine several times by hand.
• Clean air filter housing with petroleum, check air filter and renew if necessary.
• Remove covers of the exhaust opening and the suction holes.
• Connect battery. Close battery main switch.
• Install impeller.