82
At this time the user can press the BACK key to remain in the BACKUP selection sub menu or press
the HOME key to exit SD operations.
FORMAT OPERATION
The PPC4000 can be used to format the SD card. The formatting method will only be FAT32. At the
FORMAT on the SD OPS SETUP sub menu press NEXT to display the following:
Execution of each of the FORMAT command will be activated by pressing the NEXT key. After
checking the C-MODE pass code is enabled and an SD card is installed, the formatting process
begins. It would not be a good thing to interfere with this operation.
At the completion of the formatting process the display indicates the following:
The SD card can be removed by pressing lightly on the SD card and then releasing. The SD will eject
upward where it can be lifted out of its slot.
At this time the user can press the BACK key to remain in the BACKUP selection sub menu or press
the HOME key to exit SD operations.
PPC4000 OPERATION AFTER A RESTORE
When a profile only is restored it is possible that data resident in the restored profile is NOT in syn-
chronization with the corresponding parameter data. That is, the number of servos used in the profile
may not agree with the number of servos connected to the PPC4000. Also, the addresses and assign-
ment designations in the servo setup may not agree with the data in the profile. Likewise, when
parameter data is restored this data may not agree with data that is resident in the stored profiles. For
these reasons, after any or all profile only or parameter data only restore operation it will be neces-
sary to enter commissioning mode. Attempting a burner cycle with restored profile or parameter data
will result in lockout with the message NOT COMMISSIONED displayed. If profile and parameter
data are synchronized then simply press NEXT at each profile setpoint to accept the settings. At the
last profile setpoint exit commissioning mode with the C-MODE key. The number of commissioned
profile setpoints can be viewed within the INFO screen.
Since a restore operation of PROFILES & PARAMETERS causes all data to be in synchronization,
the PPC4000 will be ready to operate. Commissioning with the new data is not necessary but as
always the operator should take the necessary steps to assure the restored profile and data settings are
adequate for the burner. That is, the actual servo addresses and sensor types agree with the equipment
installed.
<
F
O
R
M
A
T
>
D
A
T
A
W
I
L
L
B
E
L
O
S
T
>
<
<
F
O
R
M
A
T
>
F
O
R
M
A
T
I
N
P
R
O
G
R
E
S
S
<
<
F
O
R
M
A
T
>
F
O
R
M
A
T
C
O
M
P
L
E
T
E
<
