Fiori DB 260, Руководство по эксплуатации и обслуживанию

Страница: 139 / 226

139
5
MAINTENANCE
id.: DB 260 REV. 00 01/07/2015
5.11.3 CHECKING AND TOPPING UP THE COOLANT LEVEL (fi g. 25)
- Open the engine compartment lid and check the air fi lter.
- Release the two hooks D and remove the cover A .
- Remove the cartridge B and replace it with a new one if necessary.
- Remove cartridges B and C , clean cartridge B by tapping its front E gently several times onto a fl at surface;
do not use compressed air.
- After cleaning the cartridge, check that there is no internal damage using a torch to illuminate the inside.
- If light fi lters through to the outside the cartridge must be replaced.
- Also replace the cartridge when the rubber seal is damaged.
- If cartridge C is soiled, do not attempt to clean the cartridges, replace them both.
- Before refi tting the cartridge, clean the inside of the fi lter body and the separator.
- Refi t the cartridge and make sure that it is properly in place.
- Close the cover A .
- It is essential to keep a stock of spare cartridges B and C , which can be ordered from the AUTHORISED
FIORI SERVICE CENTRES or directly from FIORI SPARE PARTS DEPARTMENT.
CAUTION: Use only coolant of the type and brand recommended by the manufacturer, as indicated in the
Recommended Lubricants and Fluids table in the right WATER/ANTIFREEZE percentages.
Do not remove the cap when the engine is still hot.
The fl uid is under pressure, therefore, before removing the fi ller cap, turn it slowly
to release the pressure.
- Open the engine compartment lid.
- Check the fl uid level in the tank.
- If the level is low, wait until the fl uid has reached ambient temperature, slowly unscrew the cap A and top up
until reaching the optimal level.
- Move the vehicle onto fl at ground, engage the parking brake, turn off the engine and remove the ignition
key.
DANGER:
25
MIN
A