Fimap IMx, Руководство по ремонту, Страница: 26 / 94

4-26
•
Loose the screws that block the
Brush Motor Contactor to the Elec-
tric Panel
(see fig. 4.1.11-19 )
.
• Remove the Brush Motor Contac-
tor
(see fig. 4.1.12-20 )
.
• Proceed at reverse to refit the part.
4.1.12-20
4.1.13 Brush Release Switch
IMx BB
•
Put the machine in safe conditions.
•
Remove the Function Dashboard
(see
section 4.1.2 at page 17 )
• Remove the Rear Dashboard
(see section
4.1.6 at page 18 )
•
Loose the Rubber Cap that protect
the Brush Release Switch (Rif. SBR)
(see fig. ?? )
.
•
Loose the nut that blocks the Brush
Release Switch to the Rear Dash-
board
(see fig. 4.1.13-21 )
.
• Remove the Brush Release Switch
from the Rear Dashboard.
• Proceed at reverse to refit the part.
4.1.13-21
4.1.14 Dead Man Switch
• Put the machine in safe conditions.
•
Loose the screws and remove the
handle
(see fig. 4.1.14-22 ) (see fig. 4.1.14-23 )
.
• Unplug the bipolar connector that
connects the Dead Man Switch to
the Electrical installation of the ma-
chine (it’s on the right hand side of
the handle).
• Remove the screws that secure the
microswitch support to the handle-
bar
(see fig. 4.1.14-24 ) (see fig. 4.1.14-25 )
.
•
Remove the Dead Man Switch.
• Proceed at reverse to refit the part.
4.1.14-22 4.1.14-23
4.1.14-24 4.1.14-25