Fimap IMx, Руководство по ремонту, Страница: 19 / 94

3-19
3.5 Drying system: what to do if. . .
The machine doesn’t dry well
1) The machine is switched off
⇒
Switch on the machine.
2) The machine doesn’t switch on
⇒
Refer to the proper section
(see section
3.1 at page 8 )
.
3) The vacuum motor is switched off ⇒ Switch on the vacuum motor.
4) The vacuum motor doesn’t switch
on
⇒
Refer to the proper section
(see section
3.5 at page 15 )
.
5) The machine is in ”ECO” mode ⇒ Set up the machine as per standard
configuration.
6) The squeegee is lifted up from the
floor ⇒ Lower down the squeegee.
7) The squeegee rubber blades are
worn out or broken ⇒ Rotate or replace the squeegee rub-
ber blades.
8) The recovery tank is full
⇒
Empty the recovery tank following
the proper procedure.
9) The squeegee is not properly ad-
justed
⇒
Adjust the squeegee properly follow-
ing the proper procedure
(see section 7.3.1
at page 68 )
.
10) The squeegee vacuum chamber is
stuck or dirty ⇒ Clean the squeegee vacuum cham-
ber.
11) The squeegee adapter is stuck or
dirty
⇒
Clean the squeegee adapter.
12) The vacuum hose is stuck or bro-
ken ⇒ Clean or replace the vacuum hose.
13) The vacuum hose is not properly
fitted in ⇒ Connect the vacuum hose properly.
14) The intake manifold is stuck or bro-
ken ⇒ Clean or replace the intake manifold.
15) The intake manifold is not properly
connected ⇒
Connect the intake manifold prop-
erly.
16) The vacuum filter is dirty or stuck
⇒
Disassemble and clean the vacuum
filter.
17) The vacuum cover is not well posi-
tioned or is missing ⇒ Position properly the vacuum cover.
18) The vacuum cover gasket doesn’t
adhere properly ⇒ Replace the vacuum cover gasket.