5. Press the drive pedal (4) to begin moving the machine (
Fig. 3
).
ATTENTION: The drying without scrubbing operation should only be carried out if the device was used
beforehand to carry out a scrubbing without drying operation.
2
2
3
1
1
3
4
STARTING WORK (PLUS VERSIONS)
The machine can be used in the following work modes:
• ECO-MODE, see “
”;
• MANUAL MODE, see “
”;
PROGRAM ZONE MODE (PLUS VERSION)
”.
As an example, we will look at the program mode. To begin working in this mode, proceed as follows:
1. Make all the checks listed in “
”.
2. Sit on the driver’s seat.
3. Insert the key (1) into the main switch on the control panel. Set the main switch to "I" (
Fig.1
).
4.
The first and second screen displayed allow you to check the software versions of the functions board and the display board.
5. A few seconds after turning on, the “MAIN” screen will appear (
Fig.2
).
N.B.:
by default the machine is set to the transfer program (
Fig.2
).
6. Select the desired working program with the DS selector device (see “
7. Select the desired working zone, and press the “ZONE” button (see “
PROGRAM ZONE MODE (PLUS VERSION)
”).
8.
If a working program is selected which includes “SCRUBBING WITH DRYING”, open the flow of the detergent solution into the machine's
water system and shift the knob (2) upwards (
Fig. 3
).
9. Press the drive pedal (3) to begin moving the machine (
Fig.4
).
If the program selected is “SCRUBBING WITH DRYING”, the squeegee and brush head will lower until they touch the floor. As soon as the
drive pedal is pressed, the traction motor, brush head motor and suction motor will start working. As a result, the solenoid valve will also be
activated and detergent solution will be dispensed onto the brushes. During the first few metres, check that there is sufficient solution and that
the squeegee is drying correctly. The machine will now begin to work with full efficiency until the battery is flat or until the detergent solution has
finished.
1
DRIVE
0000.00
100%
2
1
4
3
2
3
HOUR METER
The control display is in the control panel, at the top in the middle it is possible to observe the
total time the machine has been used.
The digits that precede the "." symbol identify hours, whilst the digit that follows it indicates hour
decimals (an hour decimal corresponds to six minutes).
When the “hour glass” symbol (1) is flashing it indicates that the hour meter is counting the
appliance's operating time.
BATTERY CHARGE LEVEL INDICATOR
The control display is in the control panel, at the top in the middle it is possible to observe the
charge level of the batteries.
The indicator is composed of two charge level symbols, the first represented by a graphic symbol (2), the second by a number that indicated
the charge percentage (3). With a low charge level the graphic symbol (2) will start to flash and after a few seconds it will switch off, in these
conditions take the machine to the place where its batteries can be charged.
N.B.:
a few seconds after the battery charge reaches the critical level, the brush gear motors switch off automatically. With the remaining
charge it is possible to complete the drying process before starting the recharge.
N.B.:
A few seconds after the battery charge reaches the discharge level, the suction motor switches off automatically.
DRIVE
0000.00
100%
3
2
1
22
